Open Control Panel and select Network and Sharing Center the select Change adapter settings.įrom a DOS command prompt run the command:.See below for a workaround that can be applied to SRX connections). The following solutions have been implemented by our customers successfully, Solution # 1: Disable the Juniper Network Services from the physical and virtual adapter: (If the Pulse connection is being used to connect to an SRX device, then this should not be performed.
This issue is caused due to an interoperability with the Juniper Network Service which binds to physical adapters when Pulse Desktop Client is installed.
*If you do not see this prompt, see the below fix.This article describes an issue on Windows 10 where end user experiences slow download speeds/unable to access resources over Wi-Fi adapter via Pulse Desktop client on Windows 10 After this, you should be all set to connect via Pulse Secure. Once you receive this prompt, select Allow to allow Pulse to operate. Once unlocked, select Allow, for the system to allow Pulse Secure to load.
To start the VPN session, go back to the Pulse Secure client in the top right corner of the screen.Create a new connection using the + in the bottom left corner.Open the Pulse Secure client, which should be shown at the top right corner of the screen.